Troubleshooting; Circuit Breaker; Fuses; Check List - Shoprider Valencia GK10 User Manual

Continued.....
We also recommend that the connectors between the battery pack and the main chassis are also
treated at the same time to prevent any carbon build up (round plate connectors and pins). Simply
re-assemble the scooter as per user manual after these procedures have been undertaken.
Note: Should any part of your scooter need replacing or repairing please contact your local
ROMA dealer to undertake any maintenance. Failure to do this may void your Warranty.

Troubleshooting

Circuit Breaker

Your scooter is fitted with the latest in electronic controls that are programmed to protect the
electrical system from abnormal overloads. Fitted for extra protection is a circuit breaker, which is
located on the battery pack (Fig. 11). Should there be a situation where your scooter stops for no
apparent reason please check that the circuit breaker has not tripped. Simply press the button to
reset the circuit breaker.
Note: Should the circuit breaker continue to trip turn off the scooter immediately and consult
your dealer.

Fuses

There are two 40 amp blade type fuses inside the battery pack to give protection against possible
overload on the wiring.
Caution! Do not attempt to open the battery pack to replace the fuses. Please take the battery
pack to an authorised ROMA dealer to replace any blown fuses.

Check List

If your scooter fails to operate, please check the following:
 The unit is switched on.
 All plugs and connections are firmly fixed.
 Battery level shows full charge.
 Freewheeling device is in the drive position.
 Circuit breaker has not tripped.
 Contacts between front and rear chassis are dirty.
If the freewheel device has been operated with the scooter switched on, the scooter will not
operate until the key switch has been turned off and on again.
Note: Should your scooter fail to operate after checking these possible problems, consult your
local ROMA dealer immediately.
15