Troubleshooting - Shoprider TE-9 User Manual

9. troubleshooting

9.1 - CIrCuIT BrEAkEr And FuSE
Your scooter is fitted with controls that protect the electrical system from overloads. If your
scooter stops for no reason, it may be due to the circuit breaker. The circuit breaker can be
located through a hole on the top of the rear chassis cover. On rare occasions, there may be
an overload. If this occurs, the circuit breaker will pop out. To reset, turn the key to the OFF
position, press the circuit breaker button and then turn the key to the ON position.
9.2 - IF THE SCOOTEr dOES nOT run
• Check the key is in the ON position.
• Check the circuit breaker.
• Check all plugs and connectors are firmly fixed.
• Make sure that the battery adapter is disconnected from the charger plug.
• Make sure that the freewheeling device is in the run position.
• Make sure that the batteries are fully charged
If the free wheel device has been operated with the scooter left switched on, then the scooter
will not operate until the ignition key has been switched off then on again. If after checking
these points your scooter is still not running, please contact your nearest authorised dealer.
10. warranty information
The Shoprider Scooter carries the following warranty against defects in materials
1. Chassis for a period of five years
2. All components of the unit for a period of 18 months excluding batteries, tyres, tubes and fuses
3. Batteries are covered by the battery manufacturers warranty.
Misuse of the scooter, operation not in accordance with the owners manual, exceeding the
load capacity or performance specification and modifications to the scooter by anyone without
approval by Shoprider NZ will void the warranty. Warranty only applies to the original purchaser.
Copy the following information from your dealer for future reference:
Model No.
Charger Type & No.
Battery type & No.
Your Shoprider Dealer
10
9.1
9. Troubleshooting
*Serial No.
*
Serial number located
on the rear chassis rail
Shoprider Scooters User Guide