Brake Release / Freewheel Operation - Shoprider Valencia GK10 User Manual

Continued.....
Speed Control Dial
The speed control enables you to set the maximum speed of the scooter. The tortoise being slow,
and the rabbit being the maximum.
characteristics of your scooter. Do not put excessive pressure on the dial. Only turn as far as
the stops.

Brake Release / Freewheel Operation

The brake release lever is situated under the seat at the left rear of the scooter. This lever allows you
to disengage the drive mechanism and push the scooter in 'freewheel' mode. To disengage the
drive, push the knob forward to the 'disengaged' position. The scooter can now be pushed.
Simply pull the lever back to re-engage the drive mechanism (the scooter can now be driven). The
scooter will not operate when the lever is in the disengaged position. The scooter must be turned
off and on by the key switch to reset the circuits before it will resume normal operation. The
scooter will bleep continually if the brake is disengaged when it is switched on.
Caution! Never leave the scooter unattended whilst in
freewheel mode as it will roll away down an incline.
'Freewheel' mode should only be used in an emergency
to move the scooter due to power failure. NEVER move
the scooter in this mode whilst it is occupied.
Always start at a slow speed until accustomed with the
10
When in freewheel
mode the scooter may
be pushed at a walking
pace. The scooter will
'auto-brake' if this
speed is exceeded.