Table of Contents
Advertisement
WIEGAND & DATA I/
O HARNESS
BACK-LIT JUMPER
K OR A JUMPER
1 - 2 : 12-24V DC (Power Input Terminal)
Connect to 12-24V DC power supply. The (-) supply and the (-) GND are the common grounding points of the system.
The system accepts full input voltage range with no jumper selection.
3 - 4 - 5 : OUTPUT 1 (Output Relay 1)
5 Amp relay dry contact controlled by the Group 1 User PINs or Cards for Output 1, recommended for door strike.
Terminal 3 is Normally Closed (N.C.), terminal 5 is Normally Open (N.O.) and terminal 4 is the common point of the two
contacts. Use N.C. output for Fail-safe locking device; and N.O. output for Fail-secure locking device. The relay is
programmable for Start/Stop (toggle) mode or Momentary timing mode. See programming Location 51 for the details.
6 - 7 - 8 : OUTPUT 2 (Output Relay 2)
1 Amp relay dry contact controlled by the Group 2 User PINs or Cards for Output 2, it is an auxiliary output ideally for
controlling security system or automatic operator. Terminal 6 is Normally Closed (N.C.), terminal 8 is Normally Open
(N.O.) and terminal 7 is the common point of the two contacts. The relay is programmable for Start/Stop (toggle)
mode or Momentary timing mode. See programming Location 52 for the details.
9 : EG IN ( Egress Input)
A Normally Open (N.O.) input terminal referring to (-) ground. With the help of connecting a normally opened button
to activate Output 1 for door opening in the same manner of using the Group 1 User PINs or Cards. Egress button is
usually put inside the house near the door. More than one egress buttons can be connected in parallel to this terminal.
Leave this terminal open if not used. See Programming Locations 90 and 91 for more information about the Egress
Button with other features.
10 - 11 - 12 : OUTPUT 3 (Output Relay 3)
1 Amp relay dry contact controlled by the Group 3 User PINs or Cards for Output 3 in the version "A" & "C" keypad, it is an
auxiliary output ideally for controlling security system or automatic operator. Terminal 10 is Normally Closed (N.C.), terminal
12 is Normally Open (N.O.) and terminal 11 is the common point of the two contacts. The relay is programmable for Start/Stop
(toggle) mode or Momentary timing mode. See programming Location 53 for the details.
CONNECTION TERMINALS
7
CONNECTION
TERMINALS
Hide quick links:
Advertisement
Table of Contents
