The On-Board Led Indicators; The Pacifier Tones & The Led Signals; The Jumper For Back-Lit Selection - Transmitter Solutions Dolphin DOLXP1KB Programming & Installation Manual

An inter-lock system needs two keypads and two door position sensing switches for the two doors.
19 - 20 : TAMPER N.C. (Tamper Switch Normally Closed Contact)
A normally closed dry contact while the keypad is secured on its box. It is open while keypad is separated from the
box. Connect this N.C. terminal to the 24 hour protection zone of an alarm system if necessary.
The tamper switch in the versions A and B is activated by the fixing screw of the front plate; in the versions C and D it
is activated by a magnet equipped on the back of the plastic box.

THE ON-BOARD LED INDICATORS

RED / GREEN (Right) --- It lights up in Green for Output 1 activation; and Red for Output 2 activation.
AMBER (Centre) ---------It flashes on Standby. It shows the system status in synchronization with the beep tones.
The standby flashing can be set to OFF in programming. See Location 73 for the details.
RED (Left) ----------------It lights up while one of the outputs is inhibited. It is also the Wiegand LED in reader
mode
THE PACIFIER TONES & THE LED SIGNALS
The buzzer and the amber LED indicator give following tones and signals respectively for system status:
STATUS
1) On Programming Mode
2) Successful Key Entry
3) Successful Code/ Card Entry
4) Unsuccessful Code/ Card Entry
5) Power Up Delay
6) Output Relay Activation **
7) On Standby ***
8) System Refreshing
9) Card or PIN Already Stored in System
NOTE:
* All Pacifier Tones can be ON or OFF through the programming option at Location 71
* * The Output Relay Activation beep can be selected through the programming option at Location 72
* * * The Standby flashing can be ON or OFF through the programming option at Location 73

THE JUMPER FOR BACK-LIT SELECTION

1) Full Back-lit --- The keypad gives dim backlit on standby. It turns to full backlit when a key button is pressed, then
back to dim backlit 10 seconds after the last key button is pressed.
2) Auto Back-lit --- The backlit is OFF on standby. It turns to full backlit when a key button is pressed, then back to OFF
TONES *
-----
1 Beep
2 Beeps
5 Beeps
Continuous Beeps
1 Second Long Beep
-----
-----
1 Long Beep
9
LED SIGNALS
ON
1 Flash
2 Flashes
5 Flashes
Continuous Flashes
1 Flash in 1 Seconds Interval
Fast Flashes for 2.5 Minutes
-----