Visitor Codes (For Output 1 Only) - Transmitter Solutions Dolphin DOLXP1KB Programming & Installation Manual

VISITOR CODES (FOR OUTPUT 1 ONLY)

The Visitor Codes are the temporary user codes for operating of the Output 1 (mainly for door strike in access control).
They can be programmed as "One Time Codes" or "Codes with Time Limit". The Visitor Codes will be cleared
automatically after use if they are one time codes, or, when the allowed time expires.
LOCATION
40
VISITOR ID
50 Visitor IDs for storing the codes. They are represented by a
Two-digit ID Number of
0999
= Clear all the Visitor Codes from Location 40. Please
see the Programming example below for the details.
VALID PERIOD
The codes in this box MUST be two digits and they represent the time of the operation.
00
--- One Time Code
One Time Code has no time limit but it can only be used for ONCE.
It is cleared by the system automatically after use.
01 99
- --- Time Limit in Hour(s)
The Visitor Code can be set with the valid time limit of 1 Hour to 99 Hours with a
two-digit number of 01 to 99. The visitor code is cleared by the system when
the time limit reaches.
VISITOR CODES
When a new Visitor Code is put in the same Code box, the old code is replaced.
The Visitor Codes can be 4-8 digits for the Manual Mode code entry.
The Visitor Codes MUST be in the same digit length with the Master Code for Auto Mode code entry.
The Visitor Codes can not reset Duress Output.
NOTE: All Visitor Codes will be cleared after power down to prevent extension/confusion of their valid time limit.
EXAMPLES: (Please see the following page)
VISITOR ID
01 50
-
01 50
to .
VALID PERIOD
00 01 99
or -
20
(Location 40)
VISITOR CODE VALIDATION
#
4-8 DIGITS