Advertisement
CONNECTION TERMINALS
• V+/V-: These terminals will supply power to the transmitter.
• ANT: Antenna
• RF1-4: The DOL1000-MF can control up to 4 different channels. Each RF terminal represents
a different channel.
• GO: Connects to the green LED
• NOGO: Connects to the red LED
• KEYPADUTE: Connects to the DOL1000-MF lights located in front of the keypad
• NO (Normally open): Use N.O. for equipment that requires a temporary surge of electricity to
activate. Example, Electric door locks, automated gates, push plates, etc.
• COM: Common ground
• NC (Normally closed): Use N.C. for equipment that requires a constant flow of electricity to
function properly. Example, Magnetic locks, receivers, etc.
• BATTERY 6VDC: If deciding to power the DOL1000-MF with a battery, then connect the
battery to these terminals.
• 6-24VAC/DC: If deciding to hardwire the DOL1000-MF directly to a power source, use these
terminals.
• Master Reset Button: Holding this button down for 5 seconds after reconnecting the keypad
to its power source will make the keypad beep 3 times. This will indicate that the Master Code
has been reset to 1234.
DIP SWITCHES
1. SOUND
2. LED
3. LIGHTS
4. Not used
5. Not used
6. WIRELESS MODE
a. Switching this dip switch to off will enable the toggle gate feature and switching to the
on position will disable the toggle gate feature. Disabling this feature can potentially
save battery power in the case that the toggle gate feature has been accidentally
activated. Refer to the programming chart for more details with the toggle gate feature.
7. Not used
8. Not used
Advertisement
