The Default Values Of The Keypad - Transmitter Solutions Dolphin DOLXP1KB Programming & Installation Manual

REFRESH THE SYSTEM WITH THE "REFRESHING CODE" --- 9 9 9 9
The system can be refreshed to clear all the old data stored and back to its ex-factory default values.
IMPORTANT NOTE:
Make sure that you really want to clear ALL the OLD data before entering of the Refreshing Code. The keypad will be
back with its default values like a new unit. Re-program of the desired values are necessary.
REFRESHING CODE
The Code 9 9 9 9 is for refreshing of the system. Once it is keyed in and validated with #, all the values
programmed previously will be cleared EXCEPT the Master Code.
The refreshing takes around 2.5 minutes. During the keypad is being refreshed the Status LED (Amber) flashes
fast until the end.

THE DEFAULT VALUES OF THE KEYPAD

PROGRAMMING
LOCATION
0 1 Master Code
0 2 Super User PINs
03 Common User PIN 1
04 Common User PIN 2
05 Common User PIN 3
1 0 User PINs & Cards for O/P 1
2 0 User PINs & Cards for O/P 2
3 0 User PINs & Cards for O/P 3
4 0 Visitor Codes
4 1 Duress Code for O/P 1
4 2 Duress Code for O/P 2
4 3 Duress Code for O/P 3
5 1 O/P Mode of The O/P 1
5 2 O/P Mode of The O/P 2
5 3 O/P Mode of The O/P 3
6 0 Personal Safety & Lock-out
7 0 User Code Entry Mode
7 1 Pacifier Tones ON-OFF Selection
7 2 O/P Operation Announcer
7 3 Status LED Standby Flashing ON-OFF
8 0 Door Forced Open Warning & Timing
8 1 Door Propped-up Warning & Delay
9 0 Egress Delay & Warning
9 1 Door Opening Alarm & Timer
9 4 Operation Modes & Wiegand Output
NOTE:
The DAP Code 8 0 8 0 and the Refreshing Code 9 9 9 9 are fixed in the operating system program. It can not be
changed in any ways or be influenced by the system in default setting.
PARAMETERS
REFRESHING CODE
9999
DEFAULT FUNCTIONS & VALUES
0 0 0 0 Factory Set, Not a default value *
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Time = 5 Sec, Momentary
Time = 5 Sec, Momentary
Time = 5 Sec, Momentary
Code = 1, 10 False Code Lock-out 60 Sec
Code = 2, Manual Entry Mode
Code = 1, Pacifier Tone ON
Code = 1 Sec, Notification Beep ON
Code = 1, Flashing Enabled
Code = 0, Warning Disabled
Code = 0, Warning Disabled
Code 1 = 0, Instant, No Delay
Code 2 = 1, Momentary Contact without Warning
Code = 0, Alarm O/P Disabled
Code = 0, Wiegand O/P for Valid Code Only
11
VALIDATION
#