Programming - FARFISA INTERCOMS FT 105P Installation, Programming, And User's Manual

Programming allows for personalizing the PABX according to the user's needs and for
setting the operating mode for the each individual telephone connected to the PABX.
PROGRAMMING CAN ONLY BE CARRIED OUT FROM EXTENSION 41.
When turned on, the PABX is programmed for standard use. This programming is defined
as "base" and indicated in each chapter.
Only reprogram the PABX parts that need to be modified and leave the rest unchanged.
If the PABX is connected to a DTMF external line, use telephones with DTMF dialling
and program the external line in DTMF mode, or use telephones with LD dialling and
program the external line in LD mode. If the external line is LD, mixed telephones can be
used, but the line must always be programmed in LD mode.
When programming or operating the PABX, use number 1 instead of the FLASH in case
of LD telephones without such button.
For easier programming, when necessary, press the FLASH instead of hanging up.
Note
The PABX's are supplied for operation with DTMF over external line. For LD dialling
programming, see page 14.
HOW TO RETURN TO BASE PROGRAMMING
It is possible to return to base programming at any time, by dialling code 333399 from
telephone 41.
This operation restores the base conditions indicated in the manual.
The symbol # in the field indicates that the last number programmed will not be modified
when returning to the base program, such as personal security codes.
The symbol in the field indicates that the programmed number will be cancelled.
*
Two operating modes are available, defined as day and night.
To recall the day service, dial 333301 from telephone 41 (operating mode set in the base
programming). To recall the night service, dial 333300.

PROGRAMMING

DAY/NIGHT SERVICE
5
FT
105P
208P
P
R
O
G
R
A
M
M
I
N
G