Relay Activation - FARFISA INTERCOMS FT 105P Installation, Programming, And User's Manual

Transfer an intercom call
To transfer an intercom call to an enabled user:
hang up to suspend the intercom conversation
pick up the handset
call the desired extension and hang up after the message
The called user can:
press FLASH
dial 6
- conversation with the external intercom station starts
Relay activation during conversation
This function allows for activating the relays no.1 and 2 of the intercom card ES60 or ES65
in order to operate electrical locks, turn on the staircase lighting, etc.
During the conversation with the external intercom station:
press FLASH
- dialling tone
dial the number of the relay to be activated:
1 immediate enabling of relay 1
for about 3 seconds
2 immediate enabling of relay 2
for about 3 seconds
3 enabling of relays 1 and 2 in sequence.*
* Relays 1 and 2 are not enabled at the same time, in order not to overcharge the intercom
power supply unit when used to activate electrical locks. Relay 2 is enabled with about 3
sec. delay.
This function allows for activating the 4 relays of the intercom card ES60 or ES65 (or
actuator card) for auxiliary services (lights, thermostats, heating and air conditioning
installations, etc.).
Note
Only one card at time can be added in the PABX (either intercom or actuator).
For installing the card and connection terminal block see on pages 37 and 38.

RELAY ACTIVATION

4 3
Flash+6
Flash+1
Flash+2
Flash+3
FT
105P
208P
I
N
T
E
R
C
O
M
S