Remote Activation Of Auxiliary Relays Using A Code - FARFISA INTERCOMS FT 105P Installation, Programming, And User's Manual

FT
Operation
105P
208P If the actuator card is included in the intercom card, also refer to the previous chapter for
programming and operation.
pick up the handset
- call waiting tone
I
dial 78 followed by the number of the relay to be activated
1 relay 1
2 relay 2
3 relay 3
N
4 relay 4
select the relay action (only for relays 2, 3 and 4)
0 the relay is deactivated
1 the relay is activated permanently
2 the relay is activated for 3 seconds
T
hang up after the acknowledgement tone.
E
R
Example: - dial 7821 to activate permanently relay 2. To deactivate it, dial 7820.

REMOTE ACTIVATION OF AUXILIARY RELAYS USING A CODE

C
This service only works when calling over the public line with a DTMF telephone.
It allows the user with password to activate from long distance the 4 actuator relays for
auxiliary services (lights, thermostats, heating and air conditioning installations, etc.) by
making a call to the user's number.
O
Storing the passwords for external line 1 and 2
Chose a 4-digit password for line no. 1 and no.2 (i.e. 0190, 3233, 0010, etc.) and write them
in the table below.
M
Programming
External line 1 password
External line 2 password (only FT208P) 3333-21
S
* not factory-set. If programmed, these codes will be blanked when restoring the base
programming (see page 5).
78
- dial 7832 to activate only for 3 seconds relay 3.
1, 2, 3 or 4 0, 1 or 2
Code Password to be stored
3333-20 _ _ _ _
_ _ _ _
4 4
Base
****
****