FARFISA INTERCOMS FT 105P Installation, Programming, And User's Manual page 20

FT
105P
208P
This function allows for setting the extensions for which the area code dialling are activated
(page 17). Fill-in with the chosen number the table below.
0 extension dialling not controlled
P
1 extension dialling controlled
Table
Type of service
R
Enables extension control
O
To program:
pick up the handset (dialling tone);
dial the access code 333315;
G
- only FT105P) – dial 5 digits to program 5 extensions (see Table). Always dial a
number of 5 digits even if extensions are less than 5.
- (only FT208P) – dial 8 digits to program 8 extensions (see Table). Always dial a
number of 8 digits even if extensions are less than 8.
R
wait for the acknowledgement tone and hang up.
A
M
Example: if the code below has been dialled:
M
I
3333 15 0 0 0 0 0 1 1 1
N
Note
The control of the area code dialling depends on the types of outgoing calls enabled (see
G
page 6 and next).
Example: if the extension cannot make outgoing calls, this service does not affect operation.
HOW TO ENABLE THE DIALLING CONTROL
Code
3333-15
FT105P 333315xxxxx
FT208P 333315xxxxxxxx
for extensions 41, 42, 43, 44 and 45 dialling is not controlled
for extensions 46, 47 and 48 dialling is controlled. These extensions
can dial numbers starting with the digits contained in
the enabled numbers, except for those starting with the
sequence included in the blocking numbers (see page
17).
Telephones
41 42 43 44 45 46 47 48
_ _ _ _
FT105P
FT208P
1 8
Base
_ _ _ _ 00000 000