External Hold-On Music - FARFISA INTERCOMS FT 105P Installation, Programming, And User's Manual

FT
105P
208P
This function allows for connection to an external amplifier for the paging service. The use
of an amplifier with input impedance ranging from 300 to 1000 Ohm is recommended.
O
Installation
turn off the PABX
unscrew the 2 upper screws to remove the cover
T
connect the amplifier input to terminals AMP EXT and GND
replace the cover.
H
E
Operation
R
pick up the handset
-dialling tone
dial 49
- access tone; connection with the external amplifier is made.
S
The PABX generates its own hold-on music, but can also be connected to an external music
E
source.
Installation
R
turn off the PABX
unscrew the 2 upper screws to remove the cover
connect the external music source to terminals MUS EXT and GND
V
move the jumper JP201 located next to the terminal block from INT to EXT
replace the cover.
I
C
E
Note
S
+5V voltage (0,1A maximum current) is also available to power music sources operating
at this voltage.
ACCESS TO THE EXTERNAL AMPLIFIER

EXTERNAL HOLD-ON MUSIC

3 6
49