Replacing The Footplate; Installing / Adjusting The Heel Block - Otto Bock Ventus Service Manual

Service Work

3.5.2 Replacing the Footplate

1) Loosen the Allen head screws on the clamp fitting (see Fig. 27, item 1, see Fig. 22).
2) Remove and replace the footplate.
3) If applicable: Remove and replace the clamp fitting. In order to do so, bend open the clamp fitting as far as
possible and pull it off the tube. Slide the new clamp fitting onto the tube.
4) Preinstall the footplate with the Allen head screws.
5) Rotate the footplate to the desired angle (see Fig. 27, item 2).
6) Tighten the Allen head screws to 10 Nm.

3.5.3 Installing / adjusting the heel block

The heel block can be installed using the pre-drilled holes on the footplate.
1) Install the heel block using the socket head screws on the underside of the footplate (see Fig. 23, item 1).
2) Before tightening, slide the heel block in the slot to the desired foot width (see Fig. 24).
3) Tighten the socket head screws.
14 | Ottobock
18
20
21
19
22
Ventus