Front Turn Signal Lamp; Front Fog Lamp - Chrysler Grand Voyager 2015 Manual

Front Turn Signal Lamp

1. Raise the hood to access the rear of the
headlamp housing.
2. Twist the turn signal socket and remove from
the headlamp housing, then pull the bulb
out.
3. Push the new bulb into the socket and
reinstall the socket by twisting until locked
into the headlamp housing.
Front Position Lamp
1. Raise the hood to access the rear of the
headlamp housing.
NOTE:
Access is somewhat limited. You may have
to remove the inner fender well or remove
the headlamp housing for bulb replacement.
2. Twist the socket and remove from the head-
lamp housing, then pull the bulb out.
3. Push the new bulb into the socket and
reinstall the socket by twisting until locked
into the headlamp housing.

Front Fog Lamp

NOTE:
Access to the fog lamp bulb is from the rear
of the fascia. On the left rear side of the
fascia, remove the push pin and lower the
hinged access door on the air dam.
1. From behind the bumper fascia, or the ac-
cess panel on the air dam, twist the bulb
counterclockwise, and remove bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with an oily
surface, clean the bulb with rubbing alcohol.
2. Disconnect wire harness from the bulb.
3. Reconnect the wiring harness to the new
bulb and reinstall the bulb by twisting clock-
wise.
Rear Fog Lamp
For bulb replacement, see your authorized
dealer.
Rear Turn Signal And Backup Lamp
1. Raise the liftgate.
2. Remove the tail lamp assembly by removing
the two screws from the inboard side. Use a
fiber stick or similar tool to gently pry the light
on the outboard side to disengage the two
ball studs.
Tail Lamp Mounting Screws
337