Things You Should Know About Your Uconnect® Phone - Chrysler Grand Voyager 2015 Manual

To select another cellular phone using Voice
Commands:
1. Push the Phone button to begin.
2. After the "Ready" prompt and the following
beep, say "Setup Select Phone" and follow
the prompts.
• You can also push the Voice Command
button at any time while the list is
being played, and then choose the phone
that you wish to select.
The selected phone will be used for the next
phone call. If the selected phone is not avail-
able, the Uconnect® Phone will return to using
the highest priority phone present in or near
(approximately within 30 ft [9 m]) the vehicle.
Delete Uconnect® Phone Paired Mobile
Phones
To delete mobile phones paired with the
Uconnect® phone using Voice Commands:
1. Push the Phone button to begin.
2. After the "Ready" prompt and the following
beep, say "Setup Phone Pairing."
98
3. At the next prompt, say "Delete" and follow
the prompts.
• You can also push the Phone
any time while the list is being played, and
choose the phone you wish to delete.
Things You Should Know About
Your Uconnect® Phone
Uconnect® Phone Tutorial
To hear a brief tutorial of the Uconnect® Phone
features using Voice Command:
1. Push the Phone button and say
"Uconnect® Tutorial."
Voice Training
For users experiencing difficulty with the
Uconnect® Phone recognizing their voice com-
mands or numbers, the Uconnect® Phone
Voice Training feature may be used. To enter
this training mode, from outside the Uconnect®
Phone mode (e.g., from radio mode), follow one
of the two following procedures:
1. Push and hold the Voice Command
button for five seconds until the ses-
sion begins, OR
2. Push the Voice Command
say "Voice Training," "System Training," or
"Start Voice Training."
button at
• Repeat the words and phrases when
prompted by the Uconnect® Phone.
• For best results, the Voice Training ses-
sion should be completed when the ve-
hicle is parked with the engine running, all
windows closed, and the blower fan
switched OFF.
This procedure may be repeated with a new
user. The system will adapt to the last trained
voice only.
NOTE:
To restore the Voice Command system to
factory default settings, enter the Voice
Training session via the above procedure
and follow the prompts.
Reset
To Reset all settings using Voice Command:
1. Push the Phone
button and
button.