Compass/Temperature Display — If Equipped - Chrysler Grand Voyager 2015 Manual

Messages #
Select from Main Menu using the UP or DOWN
buttons. This feature shows the number of
stored warning messages (in the # place
holder). Pushing the SELECT button will allow
you to see what the stored messages are. Push
and release the UP and DOWN buttons if there
is more than one message to step through the
remaining stored messages. Pushing the BACK
button takes you back to the Main Menu.
Units
Push and release the UP or DOWN button until
"Units" displays highlighted in the EVIC and
push the SELECT button. The EVIC, odometer,
and navigation system (if equipped) can be
changed between English and Metric units of
measure. To make your selection, scroll up or
down until the preferred setting is highlighted,
then push and release the SELECT button until
a check-mark appears next to the setting, show-
ing that the setting has been selected.
Keyless Enter-N-Go™ Display — If
Equipped
When the ENGINE START/STOP button is
pushed to change ignition switch position, cur-
184
rent ignition status will be displayed in the lower
right corner of the EVIC display to the right of
the odometer value.
Refer to "Keyless Enter-N-Go™" in "Starting
And Operating" for more information.
Compass/Temperature Display — If
Equipped
The compass readings indicate the direction the
vehicle is facing. The EVIC will display eight or
fifteen compass readings and the outside
temperature.
NOTE:
The system will display the last known out-
side temperature when starting the vehicle
and may need to be driven several minutes
before the updated temperature is dis-
played. Engine temperature can also affect
the displayed temperature; therefore, tem-
perature readings are not updated when the
vehicle is not moving.
Customer-Programmable Features
(System Setup)
Personal Settings allows you to set and recall
features when the transmission is in PARK. If
the transmission is out of PARK or the vehicle
begins moving, a warning message SYSTEM
SETUP NOT AVAILABLE VEHICLE NOT IN
PARK displays when you try to select "System
Setup" from the main menu.
Push and release the UP or DOWN button until
"System Setup" is highlighted in the main menu
of the EVIC. Then push and release the SE-
LECT button to enter the System Setup sub-
menu. Push and release the UP or DOWN
button to select a feature form the following
choices:
Language
When in this display you may select one of three
languages for all display screens, including the
trip functions and the navigation system (if
equipped). Push and release the UP or DOWN
button while in this display and scroll through
the language choices. Push and release the
SELECT button to select English, Spanish (Es-
pañol), French (Français). Then, as you con-
tinue, the information will display in the selected
language.