Chrysler Grand Voyager 2015 Manual page 601

Blu-ray™ VES™ Headphones
1 — Power Button
2 — Volume Control
3 — Channel Selection Switch
Controls
The headphone power indicator and controls
are located on the right ear cup.
NOTE:
The rear video system must be turned on
before sound can be heard from the head-
phones. To conserve battery life, the head-
phones will automatically turn off approxi-
mately three minutes after the rear video
system is turned off.
Changing The Audio Mode For Headphones
1. Ensure the Remote Control channel/screen
selector switch is in the same position as the
headphone selector switch.
NOTE:
• When both switches are on Channel 1, the
Remote is controlling Channel 1 and the
headphones are tuned to the audio of the
VES™ Channel 1.
• When both switches are on Channel 2, the
Remote is controlling Channel 2 and the
headphones are tuned to the audio of the
VES™ Channel 2.
2. Push the SOURCE button on the remote
control.
3. If the video screen is displaying a video
source (such as a DVD Video), pressing
DISPLAY shows the status on a popup ban-
ner at the bottom of the screen. Pushing the
SOURCE button will advance to the next
mode. When the mode is in an audio only
source (such as FM), the Mode Selection
menu appears on screen.
4. When the Mode Selection menu appears on
screen, use the cursor buttons on the remote
control to navigate to the available modes
and push the OK button to select the new
mode.
5. To cancel out of the Mode Selection menu,
push the BACK button on the remote control.
Replacing The Headphone Batteries
Each set of headphones requires two AAA
batteries for operation. To replace the batteries:
• Locate the battery compartment on the left
ear cup of the headphones, and then slide
the battery cover downward.
• Replace the batteries, making sure to orient
them according to the polarity diagram
shown.
• Replace the battery compartment cover.
203