Removing Key Fob From Ignition - Chrysler Grand Voyager 2015 Manual

NOTE:
You can insert the double-sided emergency
key into the lock cylinder with either side up.

Removing Key Fob From Ignition

Place the shift lever in PARK. Turn the Key Fob
to the OFF position and then remove the Key
Fob.
NOTE:
Power window switches will also remain
active for up to 10 minutes after the ignition
switch has been turned to OFF, depending
upon the accessory delay setting. Opening
either front door will cancel this feature.
WARNING!
• Before exiting a vehicle, always apply the
parking brake, shift the transmission into
PARK, and push ignition button to place
ignition in OFF mode. When leaving the
vehicle, always lock your vehicle.
• Never leave children alone in a vehicle, or
with access to an unlocked vehicle.
WARNING! (Continued)
• Allowing children to be in a vehicle unat-
tended is dangerous for a number of rea-
sons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
• Do not leave the Key Fob in or near the
vehicle, or in a location accessible to chil-
dren, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-
Go™ in the ACC or ON/RUN mode. A child
could operate power windows, other con-
trols, or move the vehicle.
• Do not leave children or animals inside
parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
(Continued)
CAUTION!
An unlocked car is an invitation to thieves.
Always remove the Key Fob from the ignition
and lock all doors when leaving the vehicle
unattended.
Key-In-Ignition Reminder
Opening the driver's door when the Key Fob is
in the ignition and the ignition switch position is
OFF or ACC, a chime will sound to remind you
to remove the key.
NOTE:
The Key-In-Ignition reminder only sounds
when the Key Fob is placed in the OFF or
ACC ignition position.
If your vehicle is equipped with Keyless Enter-
N-Go™, opening the driver's door when the
vehicle's ignition switch is placed in ACC or
ON/RUN (engine stopped) will cause the re-
minder chime to sound. Refer to "Starting Pro-
cedures" in "Starting And Operating" for further
information.
13