Table of Contents
Advertisement
4.2.3
Disconnect pilot, main and injector pipes and disconnect the wiring loom
thermocouple and ignition wire, the valve can then be removed.
Re-assemble in reverse order, refit the fuel-bed referring to section 3.1
for the correct coal layout. The fascia can now be replaced, see section
3.2 for diagram.
4.3
Removing the pilot assembly
Note : Because this appliance is fitted with an atmosphere sensing 'Oxy-
Pilot' it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
4.3.1
Prepare work area (lay down dust sheets etc.)
4.3.2
Remove the burner assembly as described in section 4.1
4.3.3
Remove the pilot shield, which is held in position by two screws.
Loosen the pilot nut and remove the two screws retaining the pilot
assembly. Unscrew the thermocouple from the gas valve.
4.3.4
Re-assemble in reverse order, Refit the fuel-bed referring to section 3.1
for the correct layout. The fascia can now be replaced, see section
3.2 for diagram.
4.4
Replacing the batteries (within the radio frequency receiver)
4.4.1
Prepare work area (lay down dust sheets etc.)
4.4.2
Firstly remove the glass fascia assembly by removing the 2 off screws
at the L/H & R/H sides and then lift the glass fascia assembly clear, see
section 3.2 for diagram.
4.4.3
The RF receiver is located on the right hand side of the product, below
the burner assembly. Remove the two off screws on the bracket at the
right hand side, this will allow the unit to be tilted downwards and
forwards. Slide the battery cover off and replace the batteries as
necessary.
4.4.4
Refit the fascia, see section 3.2 for diagram
NB
The handset uses one LR61 (9v) and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
30
Hide quick links:
Advertisement
Table of Contents
