Crankshaft - Stihl MS 261 User Manual

2
1
: Remove the clamping strap (1)
and wooden assembly block (2).
Make sure the cylinder gasket is
properly seated.
– Push the cylinder fully home.
: Insert the screws (arrows) to hold
the cylinder and gasket in
position..
– Tighten down the screws through
the holes (arrows) in the cylinder
in a crosswise pattern.
– Reassemble all other parts in the
reverse sequence.
42
6.6

Crankshaft

– Drain the fuel and oil tanks,
b b 1.1
– Remove the brake band, b 5.2
– Remove the oil pump, b 11.3
– Remove the oil suction hose,
b 11.2
– Remove the brake lever, b 5.3
QuickStop Super, b 5.4
– Remove the handlebar, b 9.6
Machines with heating, b 9.6.1
– Remove the tank housing,
b 12.11.5
– Remove the flywheel, b 7.6
– Machines with handle heating
Remove the generator, b 13.7
– Remove the short circuit wire,
b 7.7.2
– Remove the cylinder, b 6.5
– Remove the piston, b 6.7
– Remove the spiked bumper.
– Remove the insulating mat,
b 6.1
Always install new bearings and oil
seals after removing the crankshaft,
b 6.6.1 and b 6.3.
Clutch side of crankcase
1
: Remove the retaining ring (1).
Use the tools in the service tool set
5910 007 2205 for removing and
installing.
: Take out the screws (arrows).
1
: The tensioner slide (1) must butt
against the thrust pad (arrow).
MS 261, MS 261 C