Stihl MS 261 User Manual page 139

Hide thumbs Also See for MS 261:
Table of Contents

Advertisement

Installing
: Position the generator (1) with
the wire (arrow) facing the
crankcase.
– Insert the screws and tighten
them down firmly.
– Check that the generator is
properly seated.
2
3
: Connect the pin (1) and
socket (2).
– Push the insulating tube (3) over
the connector.
To reduce the risk of a short circuit,
make sure the insulating tube
completely covers the connector.
138
1
: Push the generator wire (1) to the
bottom of the recess (arrow).
: Center the connector and
1
insulating tube (1) in the
guide (arrow).
: Press the generator wire and
wiring harness into the
guides (arrows).
: Push the pin and socket
connector with insulating tube (1)
into the guide (2).
1
The wire (1) must be properly
seated in the guide (arrow) and not
project.
The flywheel must not touch the
generator wire
– this could cause a break in power
supply.
1
– Reassemble all other parts in the
reverse sequence.
1
2
1
MS 261, MS 261 C

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents