Stihl MS 261 User Manual page 100

2
: Turn the filter base (1) in direction
of ignition side.
: Disengage the filter base (1) from
the buffer (2).
– Remove the contact spring,
b 7.7.4
1
– Check the buffers (1) and replace
if necessary, b 9.5.2
Installing
– Fit the contact spring, b 7.7.4
3
2
– Use STIHL press fluid to simplify
assembly, b 15
MS 261, MS 261 C
: Engage the filter base (1) in the
buffer (2) – make sure the peg (3)
is properly seated in the buffer.
1
: Push the short short circuit (1)
through the opening (arrow).
1
: Position the short circuit wire (1)
so that it is above the ground
wire's flag terminal (arrow).
2
1
: Push the filter (1) onto the studs
and the carburetor (2).
1
– Use STIHL press fluid to simplify
: Engage the filter base (1) in the
Models with heating
1
: Fit the wire (1) in the
– Reassemble all other parts in the
1
assembly, b b 15
buffer (2).
guide (arrows).
reverse sequence.
1
2
1
99