Stihl MS 261 User Manual page 60

1
1
: Pull the wiring harness (1) out of
the guide (arrow).
1
– Remove the switch shaft (1),
b 10.1
1
: Pull the short circuit wire (1) out
from behind the tab (arrow).
MS 261, MS 261 C
1
: Pull the ring terminal (1) off the
peg (arrow).
: Remove the switch shaft (2).
– Remove the filter base, b
– Remove the carburetor, b 12.5
– Remove the carburetor carrier,
b 12.8
2
3
: Push the rubber grommet (1) out
of the crankcase (2).
: Pull out the wiring harness (3).
Installing
2
The protective tube (1) must butt
against the rubber grommet.
: If necessary, push the wiring
b 12.3
harness in the direction of the
grommet until the protective
tube (1) butts against the
grommet (2).
3
1
: Push the wiring harness (1),
cable lug (2) and ring terminal (3)
first, through the hole (arrow).
1
2 1
3
59