Stihl MS 261 User Manual page 61

Machines with heating
1
The protective tube (arrow) must
butt against the rubber grommet.
Take care not to damage the wiring
harness (arrow) when installing the
rubber grommet (1).
2
– Use STIHL press fluid to simplify
assembly, b 15
: Push the rubber grommet (1) into
the bore in the crankcase (2) until
it is properly seated.
60
2
: Fit the ground wire (1) and short
circuit wire (2) in the
guide (arrow).
The ground wire (1) must be
positioned in the guide under the
short circuit wire (2).
1
2
Ground wire: Crimped side of
terminal (1) must face the screw
head (2).
: Place the cable lug (1) in position
and fit the screw (2).
: Position the cable lug (1) so that
it points in the direction of the
cable guide.
Short circuit wire: Crimped side of
terminal (3) must face the
crankcase.
: Connect the short circuit wire
terminal (3)
– the terminal must be pushed
fully home.
1
1
: Press the short circuit wire (1)
fully into the guide (arrow).
1
2
1
: Lift the air guide shroud (1) a little
and push the ignition lead (2) into
position
3
– take care not to distort the air
guide shroud.
: Starting at the ignition module,
press the ignition lead (1) into the
guides (arrows).
– Install the carburetor carrier,
b 12.8 b
– Install the carburetor, b 12.5
1
MS 261, MS 261 C