Stihl MS 261 User Manual page 130

1
: Push the tank housing (1)
towards the ignition side and turn
it towards the clutch side until the
peg (2) is clear of the
bore (arrow).
– Pull out the tank housing, check it
and replace if necessary.
Only transfer those parts from the
old tank housing that are not
included with the replacement – see
parts list.
Installing
1
: Slide the tank housing (1),
narrow part (2) first, between the
two halves of the crankcase.
MS 261, MS 261 C
2
: Fit the antivibration spring (1) in
the recess (arrow) in the
crankcase.
1
: Push the tank housing (1)
towards the ignition side and turn
it until the peg (2) is inside the
bore (arrow).
2
1
1
: Lift the tank housing (2).
: Tighten down the screw (1) firmly.
– Install the stop buffer, b
– Reassemble all other parts in the
reverse sequence.
2
2
b 9.5
129