Stihl MS 261 User Manual page 95

Installing
: Line up the throttle rod (1) (see
illustration).
: Push the throttle rod (1) between
the tank housing and air guide
shroud and rotate it about 90° at
the same time.
: Pass the throttle rod (1) through
the opening (arrow).
: Turn the bent end (1) clockwise
and push it under the throttle
trigger in the direction of the
engine.
94
1
: Push the throttle rod (1) into the
guide (2) in the carburetor carrier
until it snaps into position.
– Install the throttle trigger, b
– Check operation
– the throttle lever on the
carburetor must move upwards
when then throttle trigger is
pulled.
1
Engage peg of filter base (1) in
buffer (arrow) at ignition side.
2
: Swing the filter base (1) in
direction of clutch side so that it is
against the carburetor (2) studs.
2
1
: Push the filter (1) onto the studs
b 10.2
: Engage the filter base (1) in the
1
Models with heating
: Fit the wire (1) in the
– Reassemble all other parts in the
1
and the carburetor.
buffer (2).
guide (arrows).
reverse sequence.
MS 261, MS 261 C
1
1
2
1