Stihl MS 261 User Manual page 86

1
– Install the retainer (1), b 9.2.1
2
: Straighten the wire (2) and fit it
between the crankcase and tank
housing.
: Push the handlebar (1) into its
seat (arrows)
– do not pinch the wires.
1
2
: Position the wire (1) in the upper
guide (arrows).
Lay the wires without loops and
snugly against the housing.
: Fit the insulating hose (2).
MS 261, MS 261 C
1
: Push the pin and socket
connector together.
: Push the insulating tube (1) over
the connector.
1
: Push the wire fully into the
guide (arrows).
1
: Push the pin and socket
connector with insulating tube (1)
into the guide (arrows).
: Install the wiring harness (1),
b 13.8 b
2
: Push the retainer (1) into the seat
so that the wires with insulating
tube (2) locate in the
guide (arrow).
Make sure that the wires are not
pinched.
1
The peg (1) must engage the seat
(arrow).
1
1
85