Changing The Cutter Mode - Star Micronics FVP10 series Hardware Manual

4-4. Changing the Cutter Mode
To change the cutter mode from partial to full, follow the instructions given below.
To change the cutter mode, change Dip switch DIPSW1-10 (see chapter 12, "Dip Switch Settings").
(1) Pull the cover open lever toward you, and pull the front cover out to open it.
AC paper guide
(2) Loosen the two screws at the fixed blade section.
Note:
To keep the screws from falling, only turn them once or twice.
(3) Move the fixed blade lever in the direction of the arrow until it stops.
Loosen the screw
Fixed blade
(4) Tighten the two screws.
(5) Loosen the screw on either side of the AC paper guide section.
Note:
To keep the screws from falling, only turn them once or twice.
(6) Lower the AC paper guide until it stops. Then, tighten the two screws.
Screw
Note:
Do not change the cutter mode while the printer is in use.
AC paper guide
- 21 -
Screw
Fixed blade
Loosen the screw
Fixed blade lever