Setting Up Auto Connection - Star Micronics FVP10 series Hardware Manual

3-7-4. Setting up Auto Connection

Setting up from the Main Unit for the FVP10
Note :
If you want to change it from OFF to ON, please follow the same procedure.
(1) When paper is loaded in the printer and it is turned on, the [POWER] LED(green) on the front of the printer turns
on.
(2)
(3) The following information is printed. After that, turn the printer off and then back on again to set "Auto Connec -
tion" to OFF.
< Current Setting >
Auto Connection : OFF
To enable this setting, turn
Printer Power OFF and turn ON.
(4)
dure by self-printing".
Note : Only Bluetooth Firmware Version 2.0 or later allows you to switch ON/OFF by pushing the [RST] button.
 Setting from the Software
After pairing your device and the FVP10, change "Auto Connection" in the following application provided by our company.
 iOS: Download "Star Setting Utility" from the following Web site.
http://www.star-m.jp/prjump/000003.html
 Android: Download "Star Setting Utility" from the following Web site.
http://www.star-m.jp/prjump/000004.html
 Windows: Download "Star Bluetooth Utility" from the following Web site.
http://www.star-m.jp/prjump/000006.html
RST button
- 15 -
-
-