Connecting To A Peripheral Device - Star Micronics FVP10 series Hardware Manual

3-6. Connecting to a Peripheral Device
You can connect a peripheral device to the printer using a modular plug.
Follow the instructions given below. For details about the recommended type of modular plug, see chapter 17, "Peripheral
Drive Circuit".
(1) Make sure that the AC adapter's power cable plug is not connected to the outlet.
(2) Connect the end of the cable to the peripheral drive connector on the rear panel of the printer.
Connect the other end of the cable to the modular jack of the peripheral device.
CAUTION
Do not connect a telephone line into the peripheral drive connector. Failure to observe this may result in damage
to the printer.
Also, for safety purposes, do not connect wiring to the external drive connector if there is a chance it may carry
peripheral voltage.
- 11 -