Setting The Slide Lever Position - Star Micronics FVP10 series Hardware Manual

4-3-2. Setting the Slide Lever Position
By factory default, the tension lever is set for paper thicknesses between 65 µm and 100 µm.
To use paper whose thickness is greater than 100 µm and up to 150 µm, change the slide lever position according to the in-
structions given below.
(1) Pull the cover open lever toward you, and pull the front cover out to open it.
(2) While pushing the slide lever that is on the left side of the case inward, change the lever position.
Position for paper whose thickness is between 65 µm and 100 µm
Position for paper thicknesses greater than 100 µm and up to 150 µm
1 2
Slide lever
2
- 20 -
2
1
2
1