Usb And Poweredusb Interface Model - Star Micronics FVP10 series Hardware Manual

12-3. USB and PoweredUSB Interface Model
■ DIP-SW 1
Switch
1-1 Emulation
STAR line mode
1-2
ESC/POS mode
1-3 Reserved
1-4 Sensor adjustment
1-5 USB mode
Handshaking conditions
1-6
(conditions for BUSY)
1-7 ASB function*1
STAR line mode
1-8
ESC/POS mode
1-9 Low peak current mode
1-10 Installed cutter type
*1 ASB function:
Automatically sends a status signal to the host whenever the printer status changes (cover open, paper out, error, etc.).
For details, see the separate command specifications (Star Line mode and ESC/POS mode).
*2 NSB function:
Automatically sends a status signal whenever the printer switches to reverse transfer mode.
For details, see the separate command specifications (Star Line mode).
■ DIP-SW 2
Switch
2-1 to 2-4
By factory default, all settings are set to ON.
DIP-SW 1
Function
Reserved
Resolution correction
Printer Class
Vendor Class
Printer
NSB
Class
Vendor
function*2
Class
Reserved
Function
–
DIP-SW 2
ON
STAR line mode
Always ON
203 dpi
Always ON
Invalid
Printer Class
Receive buffer full or
offline
Valid
Invalid
Valid
Invalid
Always ON
Invalid
Partial cut
ON
Always ON
- 47 -
OFF
ESC/POS mode
180 dpi
Valid
Vendor Class
Receive buffer full
Invalid
Valid
Invalid
Valid
Valid
Full cut
OFF