Star Micronics FVP10 series Hardware Manual page 38

(6) Turn VR2 so that both the POWER lamp (green) and ERROR lamp (red) light.
(7) Press the FEED button. The LED will flash, and the printer will enter sensor check mode.
(8) Open the front cover, set a paper roll into the printer, and close the front cover.
Check that the POWER lamp (green) is lit and the ERROR lamp (red) is off.
(9) Open the front cover, remove the paper roll from the printer, and close the front cover.
Check that both the POWER lamp (green) and ERROR lamp (red) are lit.
(10) Turn the printer off, and set DIP switches DIPSW1-4, DIPSW1-5, DIPSW1-6, and DIPSW1-7 to their original settings.
(11) Attach the DIP switch cover.
VR1 VR2
- 32 -