Initializing Settings - Star Micronics FVP10 series Hardware Manual

■

Initializing Settings

To initialize the settings, use the push switch as follows:
(1) With the printer in normal operating mode, hold down the push switch for 1 to 5 seconds.
The green and red LEDs flash with a regular pattern.
Push switch
(2) Push the switch again. The red and green LEDs both turn off, and the Ethernet interface settings are returned to their
factory default values.
(3) When the Ethernet interface initialization has been completed, the printer automatically reboots.
■
LED Display
Green LED ........Lights when 100BASE-TX is detected on the other end of the connection
Red LED............Lights when packets are received
LED
- 49 -