Accessing The Monitor Program Using Telnet - Alvarion BreezeAccess II System Manual

Accessing the Monitor Program
Accessing the Monitor
Program using Telnet
1. Connect a PC to the Ethernet port of the unit. See the table below to
determine the type of cable. Configure the PC's IP parameters to enable
connectivity with the unit (the default IP Address is 10.0.0.1). Run the Telnet
application.
Table 1-2: Required Type of Ethernet Cable
Unit Type
All SU-R Units and Subscriber Units that support a
single Ethernet device (SU-1D, SU-1D1V)
Subscriber Units (excluding SU-R Units) that
support multiple Ethernet devices
(SU-BD, SU-BD1V)
Access Units
GPS module
2. The Select Access Level menu appears. Select the access level according to
your authorized access level. You will be requested to enter your password.
After entering the correct password press Enter.
The Main Menu appears.
BreezeACCESS/AU-BS
Official Release Version – 4.0.40
Release Date: Thu Dec 20 20:21:36 2001
Main Menu
=====================
1 – Info Screens
2 – Unit Control
3 – Basic Configuration
4 – Site Survey
5 – Advanced Configuration
X - Exit
>>>
Figure 1-1: Main Menu – Administrator Access Rights (SU and AU)
! The appearance of the Main Menu varies in accordance with the set
access level.For users with Read Only access rights, only the Info
Connection to a
PC
Straight
Crossed
Crossed
Straight
BreezeACCESS Version 4.5 System Manual
1-3
Connection to a
Hub
NA
Straight
Straight
Crossed