Alvarion BreezeAccess II System Manual page 215

Menus and Parameters
transmitted by the AU back to the wireless link devices, as well as to
the wired LAN. If disabled, these packets are sent only to the local
wired LAN and are not sent back to the wireless link. Disable
Broadcast Relaying if you are sure that all broadcast messages
from the wireless link will be destined to the wired LAN.
The default selection is Enable.
! Unicast Relaying (AU only) – Determines whether the unit performs
Unicast relaying. When Unicast Relaying is enabled, Unicast
packets originating in devices on the wireless link can be
transmitted back to the wireless link devices. If this parameter is
disabled, these packets are not sent to the wireless link even if they
are intended for devices on the wireless link. Disable Unicast
Relaying only if you know that all unicast messages from the
wireless link will be destined to the local wired LAN.
The default selection is Enable.
! Ports Control (SU only) - To enable/disable the Ethernet and/or
Voice port. The Ports Control submenu includes the following
options:
" Ethernet Port Control - To enable/disable non-management
traffic to/from the Ethernet port. All current data sessions will
be terminated. The unit may still be managed via the Ethernet
port even when it is disabled for data traffic.
The default selection is Enable.
" Voice Port Control (SU with voice support) - To enable/disable
the voice port. When the voice port it disabled, there will not be a
dial tone. An existing connection will be terminated.
The default selection is Enable.
! Show Bridge Parameters – Displays the current values of the
Bridge parameters.
BreezeACCESS Version 4.5 System Manual
2-85