Alvarion BreezeAccess II System Manual page 240

2-110
The default is Enable
National Telephony Parameters
! Telephony Country Standard – Selects the call progress tones
standard. The following options are available:
" Proprietary – Allows definition of specific tones (see below).
" Germany
" Sweden
" France
" United Kingdom
" Belgium
" USA
" Chile
The default selection is USA.
! Call Progress Tones
" Dial Tone –Defines the dial tone transmitted to the earphone to
indicate that the call can be supported by the system and that
the caller may start dialing.
" Ring-Back Tone – Defines the tone transmitted to the earphone
to indicate that the telephone of the called party is ringing.
" Busy Tone – Defines the tone transmitted to the earphone to
indicate that the telephone of the called party is busy.
" Congestion Tone - Defines the tone transmitted to the
earphone to indicate that the system cannot currently support
the call (e.g. if a line is not available since the AU currently
supports the maximum allowed number of voice sessions).
" Error Tone – Defines the tone transmitted to the earphone to
indicate that the system cannot currently support the call (e.g. if
for any reason the call was disconnected because of a problem in
the wireless link or incompatible capabilities) or if the user did
not hang up after exceeding the specified duration of the Dial,
Ring Back, Busy or Congestion Tones.
" High Level Error Tone – Defines the high level tone transmitted
to the earphone to better attract the attention of the user if he
did not hang up after exceeding the specified duration of the
Error Tone.
The various tones are defined by specifying the following parameters
(the default values for all parameters are country-specific):
#
Manual Revision: 1.0
BreezeACCESS Version 4.5 Operations and Administration
Frequency 1 – One of two frequencies that can be used for
generating the applicable tone.
Valid values are 0-3000 (in Hz).