Alvarion BreezeAccess II System Manual page 265

Hide thumbs Also See for BreezeAccess II:
Table of Contents

Advertisement

Appendix B
NOTE:
If you are upgrading a Subscriber Unit which is not associated with an AU, the unit will
reset every five minute (approximately) and the following message will be displayed:
FTL: file src\wpscan.c line 262 Too large number of scanning
attempts
The unit will reset and it will take more than a minute before you can re-establish the
connection to it. You should either have the SU associated with an AU before starting
the loading process or complete the loading process before the unit resets. Otherwise
you will have to try again until you complete the loading process.
When loading is completed the following message is displayed: Loading
operation has been completed successfully.
The FLASH memory can store two software versions. One version is
called Current and the second version is called Shadow. The new
version is loaded into the Shadow (backup) FLASH memory.
To check that the new firmware was loaded properly, view the firmware
versions stored in the FLASH using the following procedure:
1.
From the Main Menu, select 2 – Unit Control.
The Unit Control menu opens.
2.
From the Unit Control menu, select 5 – Flash Memory Control.
The Flash Memory Control menu opens.
3.
From the Flash Memory Control menu, select S – Show Flash
Versions.
The display appears as follows:
Flash Versions
===========
Current Version:
Shadow Version:
Version After Reset:3.0.39
From the Flash Memory Control menu select the active software version,
using the following procedures:
To activate the backup (shadow) version:
1.
From the Flash Memory Control menu select 1 - Reset and Boot from
Shadow Version.
The Reset and Boot from Shadow Version menu opens.
2.
Select 1 – Reset Now and press ENTER.
3.
The unit resets and the Shadow version is used as the newactive
version. Note that after the next reset, the Current version will be
activated again.
If the active version is the Shadow version and you wish to
continue using it after the next Reset, use the following procedure:
3.0.39
4.0.40
BreezeACCESS Version 4.5 System Manual
B-5

Advertisement

Table of Contents
loading

Table of Contents