Place The Sorter On The Sorter Seat; Remove The Rear Cabinet Panel From The Copier And Cut Out The Notch In The Cabinet Panel; Connect The Sorter Connectors; Reattach The Rear Cabinet Panel - Sharp SF-2040 Service Manual

4. Place the sorter on the sorter seat.

While holding the handle, place the sorter on the sorter seat's guide
rails and push it gently as far back as it will go.
When doing this, confirm that the rollers at the front of the sorter are
correctly seated on the sorter seat.
Guide rail
Rear
Guide roller
Sorter
Sorter seat
5. Remove the rear cabinet panel from the copier
and cut out the notch in the cabinet panel.
Remove the four screws which secure the rear cabinet panel of the
copier to remove the rear cabinet panel.
Cut out the notch (one location) in the cabinet panel.
Mounting
screws
Rear cabinet
panel
Mounting screws
Guide rail Front
Guide roller
Sorter
Sorter seat
Handle
Notch

6. Connect the sorter connectors.

Use the two bracket mounting screws to secure the bracket attached
to the sorter harness to the frame of the copier.
Connect the 6-pin and 10-pin sorter connectors to the 6-pin and
10-pin connectors of the copier and insert the tie band into the hole
under the board installation part.
Bracket
mounting
screws

7. Reattach the rear cabinet panel.

Use the four mounting screws to reattach the rear cabinet panel
removed in step (4) in its original position.
Mounting
screws
Rear cabinet
panel
Mounting screws

8. Reattach the front panel of the sorter.

Use the four mounting screws to reattach the front panel of the sorter
removed in step (3) in its original position.
5 – 20
Bracket mounting
screws
Bracket
Tie band
6-pin connector
10-pin connector
Mounting
screws
Mounting
screws
Front panel
of sorter