Sharp SF-2040 Service Manual page 43

4. Attach the rail to the sorter.
Insert the rail into the rail mounting anchor, on the bottom of the
sorter, and attach them with the 2 rail screws A (M4 x 6) and 1 rail
screw B (M4 x 6).
Rail screws A
5. Fit the rail mounting plate onto the rail.
Insert the rail between the rollers on the rail mounting plate as shown
in the figure.
Rail mounting plate
Rollers
6. Attach the rail mounting plate to the copier desk.
Slide the rail, which was just attached to the sorter, under the copier
as shown in the figure. Attach the rail mounting plate to the copier
with the 2 rail mounting plate screws (M4 x 14).
Rail mounting plate screws
Rail
Rail mounting anchor
Rail
Rail screws B
Rollers
Rail
Desk
Rail mounting plate
7. Confirm that the staple sorter can be attached
and detached correctly.
1 Latch and unlatch the staple sorter from the copier to confirm that
it moves smoothly.
2 Confirm that the staple sorter locks into place beside the copier.
If not, adjust the height of the sorter mounting plate until the staple
sorter locks securely into place.
Soter mounting plate
8. Remove the copier's rear cabinet panel and cut
off the cut portion of the left cabinet.
Remove the screws securing the copier's rear cabinet panel and take
the panel off.
Next, cut off the cut portion (1 location) of the left cabinet panel.
Mounting
screws
Rear cabinet
panel
Mounting screws
5 – 15
Cut portion