Sf-A55; Mount The Adf Onto The Copier; Adjust The Angle Of Adf Connector - Sharp SF-2040 Service Manual

(2) SF-A55

ADF mounting screws
(2pcs.)
Unplug the copier and follow the procedure below.

1. Mount the ADF onto the copier.

Remove the 2 cut-outs from the upper cabinet panel of the copier.
Install the 2 ADF mounting screws.
ADF mounting screw
ADF tray
ADF securing screws
(2pcs.)
Cut-outs
Upper rear
cabinet panel
ADF mounting screw
Fit the holes in the hinges of the ADF onto the ADF mounting screws
and secure the ADF with the two ADF securing screws.
ADF securing screw
ADF mounting screw
ADF securing screw
2. Adjust the angle of ADF.
Loosen the two fixed screws for the angle adjusting panel which are
located on the hinge angle and then fasten the loosened screws while
raising the angle adjusting panel completely.
5 – 10
Angle adjusting panel
Fixed screws