Mounting Of The Staple Sorter Onto The Copier - Sharp SF-2040 Service Manual

When not performed on the skid
Open the sorter protection mat, as shown in the figure, and position it
against the sorter's casters. Lay the sorter down on the protection
mat.
Next, remove the securing fixtures (2).
Remove the caster screws (2 per caster) and take off the 4 casters.
Next, attach the casters and caster spacers using 2 screws each (M4
x 50) as shown in the figure.
Caster spacers
Caster spacer Casters
Remove all the securing tape (
materials ( ) shown in the figures below.
Securing fixtures
Sorter protection mat
3
2
1
2
Caster screws
Casters
Caster spacer
Caster screws
) and securing
Unplug the copier's power cord before carrying out
the following procedure.
A. Mounting of the staple sorter onto the copier.
1. Attach the sorter mounting plate.
Remove the screws (2) from the copier's upper left cabinet panel.
Attach the sorter mounting plate with the 2 sorter mounting plate
screws (M4 x 12).
The sorter mounting plate screw holes are elongated; tighten the
screws so that the sorter mounting plate hangs down in its lowest
position.
Sorter mounting
plate screws
2. Attach the support guide.
Attach the support guide by attaching its pawls (2 locations) to the
inside of the copier's paper output section.
3. Cut off the cut portions of the desk's left cabinet
panel.
Cut off the 2 cut portions of the desk's left cabinet panel.
Cut portions
Desk
5 – 14
Upper left cabinet panel screws
Sorter mounting
plate
Pawls
Support guide