Example 3: System Configuration; Example 3: Admin Context Configuration; Example 3: Department 1 Context Configuration; Example 3: Department 2 Context Configuration - Cisco PIX 500 Series Configuration Manual

Appendix B Sample Configurations
•
•

Example 3: System Configuration

You must first enable multiple context mode using the mode multiple command. The mode is not stored
in the configuration file, even though it endures reboots. Enter the show mode command to view the
current mode.
hostname Ubik
password pkd55
enable password deckard69
asdm image disk0:/asdm.bin
boot system disk0:/image.bin
mac-address auto
admin-context admin
interface gigabitethernet 0/0
no shutdown
interface gigabitethernet 0/0.200
vlan 200
no shutdown
interface gigabitethernet 0/1
shutdown
interface gigabitethernet 0/1.201
vlan 201
no shutdown
interface gigabitethernet 0/1.202
vlan 202
no shutdown
interface gigabitethernet 0/1.300
vlan 300
no shutdown
context admin
allocate-interface gigabitethernet 0/0.200
allocate-interface gigabitethernet 0/1.201
allocate-interface gigabitethernet 0/1.300
config-url disk0://admin.cfg
context department1
allocate-interface gigabitethernet 0/0.200
allocate-interface gigabitethernet 0/1.202
allocate-interface gigabitethernet 0/1.300
config-url ftp://admin:passw0rd@10.1.0.16/dept1.cfg
context department2
allocate-interface gigabitethernet 0/0.200
allocate-interface gigabitethernet 0/1.203
allocate-interface gigabitethernet 0/1.300
config-url ftp://admin:passw0rd@10.1.0.16/dept2.cfg

Example 3: Admin Context Configuration

hostname Admin
interface gigabitethernet 0/0.200
nameif outside
security-level 0
ip address 209.165.201.3 255.255.255.224
no shutdown
interface gigabitethernet 0/0.201
nameif inside
OL-12172-03
Example 3: Department 1 Context Configuration, page B-10
Example 3: Department 2 Context Configuration, page B-11
Example 3: Shared Resources for Multiple Contexts
Cisco Security Appliance Command Line Configuration Guide
B-9