Protocols And Applications; Tcp And Udp Ports - Cisco PIX 500 Series Configuration Manual

Appendix D Addresses, Protocols, and Ports

Protocols and Applications

Table D-4
commands.
Table D-4
Literal Value Description
ah
eigrp
esp
gre
icmp
icmp6 58
igmp
igrp
ip
ipinip 4
ipsec
nos
ospf
pcp
pim
pptp
snp
tcp
udp
Protocol numbers can be viewed online at the IANA website:
http://www.iana.org/assignments/protocol-numbers

TCP and UDP Ports

Table D-5
commands. See the following caveats:
•
OL-12172-03
lists the protocol literal values and port numbers; either can be entered in security appliance
Protocol Literal Values
51 Authentication Header for IPv6, RFC 1826.
88 Enhanced Interior Gateway Routing Protocol.
50 Encapsulated Security Payload for IPv6, RFC 1827.
47 Generic Routing Encapsulation.
1 Internet Control Message Protocol, RFC 792.
Internet Control Message Protocol for IPv6, RFC 2463.
2 Internet Group Management Protocol, RFC 1112.
9 Interior Gateway Routing Protocol.
0 Internet Protocol.
IP-in-IP encapsulation.
50 IP Security. Entering the ipsec protocol literal is
equivalent to entering the esp protocol literal.
94 Network Operating System (Novell's NetWare).
89 Open Shortest Path First routing protocol, RFC 1247.
108 Payload Compression Protocol.
103 Protocol Independent Multicast.
47 Point-to-Point Tunneling Protocol. Entering the pptp
protocol literal is equivalent to entering the gre protocol
literal.
109 Sitara Networks Protocol.
6 Transmission Control Protocol, RFC 793.
17 User Datagram Protocol, RFC 768.
lists the literal values and port numbers; either can be entered in security appliance
The security appliance uses port 1521 for SQL*Net. This is the default port used by Oracle for
SQL*Net. This value, however, does not agree with IANA port assignments.
Cisco Security Appliance Command Line Configuration Guide
Protocols and Applications
D-11