Lubrication - Centsys D5-Evo Installation Manual

9. Lubrication

Do not attempt to run the operator
without first filling the gearbox with
The internal gearset of the D5-Evo is lubricated by means of an oil bath

In order to prevent possible leakage during shipping, the unit is shipped with no oil

inside the gearbox. A bottle containing 80ml of a special synthetic oil is included with
the product, and this must be introduced before operating the product. (Product
code: OIL80ML0X0/H)
It is more convenient to introduce oil before bolting the unit down, as shown in
Figure 7.
The D5-Evo does not require routine oil changes. However in the event of the
unit losing oil due to stripping down or mechanical damage, the correct
replacement oil is Castrol SAF X0 75W-90 synthetic final drive lubricant.
If the gearbox is bolted down in the horizontal position during filling, the correct
level is reached when the oil level is in the flat section of the dipstick.
Emptying the 80ml bottle of oil provided will give sufficient oil.
Put 80ml oil in here
Oil specifications
Centurion Systems (Pty) Ltd product
code: OIL80ML0X0/H
Oil filling procedure
1. Lift the cover of the operator
2. Remove the battery so that you can
gain access to the coloured filler plug
3. Remove the coloured oil filler plug by
levering it out with a screwdriver
4. Empty the contents of the oil bottle into
the gearbox (80ml)
5. Refit the coloured oil filler cap
FIGURE 7 OPERATOR LUBRICATION
page 15