Clearing Finisher Messages - Lexmark C910 Service Manual

5055-01X

Clearing Finisher Messages

Message
Bin <X> Full
Check Finisher
Installation
Close Finisher Top
Cover
Empty Box
Leave Staple Job
in Finisher
Staples Empty
Stapler Missing
Insert Hole Punch
Box
2-56
Service Manual
Remove the stack of paper from the bin to clear the
message. If you assigned the bin a name, the bin
name is displayed instead of the bin number. Press
Go to clear the message and continue printing.
Make sure the finisher is flush against the printer. If
this does not resolve the problem, go to
Service Check" on page 2-74
set switch.
Close the finisher top cover and align the finisher flush
against the printer to clear the message.
Empty the hole punch box to continue printing.
The printer has detected a paper jam while printing a
job that must be stapled. The message Leave Staple
Job in Finisher alternates with the Paper Jam
message. Leave the printed pages on the stacking
tray inside the finisher and clear the paper jam in the
printer. Press Go to clear the message and continue
printing.
Replace the staple cartridge if you want to continue
stapling. You can press Go to clear the message and
continue printing without stapling.
The staple holder is missing. Place the staple holder in
the stapler to clear the message. Go to
Service Check" on page 2-74
sensor.
Install the hole punch box. The printer will
automatically clear the message. Go to
Service Check" on page 2-74
box detect sensor.
Solution
to check the finisher
to check the no staple
to check the punch
"Finisher
"Finisher
"Finisher