Table of Contents
Advertisement
STEP 8 – SLIDE DISHWASHER PARTIALLY INTO
OPENING
Do not use dishwasher until completely installed.
Do not push down on open door.
Failure to follow these instructions can result in serious injury or cuts.
1. Slide dishwasher into the opening a few inches at a time.
NOTE: Do not push against the front of the panel or on the console – they will
dent.
2. Position power supply.
•
If dishwasher has a power supply cord, insert power supply cord into the hole
cut into the cabinet.
•
If using a direct-wire connection, check that the wiring is on the right front
side of opening.
3. Slowly move dishwasher completely into cabinet opening. As you proceed,
pull the drain hose through the opening under the sink. Stop pushing when the
dishwasher is a few inches forward of the adjacent cabinetry.
4. Make sure the drain hose is not kinked under the dishwasher and there is no
interference with the water line and wiring or any other component.
WARNING
Tip Over Hazard
21
Advertisement
Table of Contents
