Using The Dishwasher - Haier HLV0845FSSS Owner's Manual

Built-in dishwasher, portable dishwasher
Table of Contents

Advertisement

Available languages

Available languages

USING THE DISHWASHER

Features and appearance will vary throughout this manual.
Load Dishwasher
1
For best dishwashing results, follow the loading guidelines found in the Loading section. No pre-rinsing of normal food soil is required. Scrape
off hard soils, including bones, toothpicks, skins, and seeds. Remove leafy vegetables, meat trimmings, and excessive amounts of grease or
oil.
Add Detergent
2
Add needed amount of detergent to the detergent dispenser. See Dispensers section.
Add Rinse Agent
3
Add rinse agent to the rinse agent dispenser. See Dispensers section.
NOTE: The use of rinse aid can further enhance the dishwasher's drying performance.
Select Cycle
4
Open the door and press the Cycle Select pad for the desired wash cycle. The light next to the Cycle Select pad will be lit to indicate which
wash cycle has been selected.
NOTE: Cycle times vary based on soil level, water temperature, and options selected.
The cycle must be selected with the door in the open position. The cycle will not start until the Start pad is pushed and the door is closed within 4 seconds.
AutoSense
This cycle automatically senses the soil level and adjusts the wash cycle accordingly. It is meant
(HLV0845FSSS)
for daily, regular, or typical use to completely wash a full load of normally soiled dishes and is designed to conserve both
Smart
water and energy. NOTE: AutoSense was used to rate the energy efficiency of this dishwasher. *Time range: 1 hour 30
(QDP225SSPSS)
minutes - 2 hours.
Heavy
This cycle is meant for heavily soiled dishes, cookware, pots, or pans with dried-on or baked-on soils. Everyday dishes are
safe to be used in this cycle. *Time: 2 hours 10 minutes.
Light
This cycle is for lightly soiled dishes. It is safe for china and crystal with no options selected. *Time: 48 minutes.
(HLV0845FSSS)
Quick
(QDP225SSPSS)
*Washing time only. Does not include drying time, Auto Hot Start, or options. NOTE: If the incoming water temperature is too low, the Auto
Hot Start feature may add up to 11 minutes of additional time.
Select Options
5
Wash Temp
Allows you to select a higher wash temperature. These options are only available for Heavy and AutoSense cycles. Press
the Wash Temp pad until the light next to the desired option comes on.
Boost
This option raises water temperature and extends cycle time in order to achieve better wash performance.
(HLV0845FSSS)
High Temp
(QDP225SSPSS)
Sanitize.
This option raises the water temperature in the final rinse to sanitize your dishware. The cycle length may vary depending
on the temperature of your inlet water.
NOTE: Cycles using this option are monitored for sanitization requirements. If the cycle is interrupted during or after the
main wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved, the
sanitizing conditions may not be met. In these cases, the Sanitized light will not illuminate at the end of the cycle. Utilizing
this option will modify the cycle to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
Delay
This option allows you to delay the start of a wash cycle for up to 12 hours. With the door open and a cycle selected, press
Start
the Delay Start pad to choose the number of hours you want to delay the start of the wash cycle. The hours will show in
the display window. NOTE: You may cancel the Delay Start timer by holding the Start pad for 3 seconds. This will also can-
cel the wash cycle.
Control
You can lock the controls to prevent selections from being made. You can also lock the controls after you have started a
Lock
cycle to prevent cycle changes. For example, children cannot accidentally start the dishwasher by pressing pads with this
option selected.
To LOCK/UNLOCK the dishwasher control, press and hold the Cycle Select and Wash Temp pads for 3 seconds. The lock
control light (
) will turn on to indicate the control is locked and will turn off to indicate the control is unlocked.
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qdp225sspss

Table of Contents