Table of Contents
Advertisement
Option 4 – (No Garbage Disposal - No Air Gap):
1. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to waste tee with 11/2" to 2" (3.8 to 5 cm) screw-type clamp*.
This connection must be before the drain trap and at least 20" (50.8 cm) above the
floor where dishwasher will be installed. It is recommended that the drain hose
be looped up and securely fastened to the underside of the counter. See "Drain
Requirements."
a
e
d
*Parts available from local plumbing supply store.
STEP 5B - PREPARE CABINET OPENING WHERE THERE
ARE NO EXISTING UTILITY HOOKUPS
INSTALL ELECTRICAL CONNECTION
Disconnect electrical power at the fuse box or circuit breaker box
before installing dishwasher.
Failure to do so can result in death or electrical shock.
Method 1 - Direct Wire
1. Drill a 3/4" (1.9 cm) hole into the right-hand cabinet, or the right-hand side of the
back or floor of the opening. See following graphic for preferred and optional
locations.
16
b
c
WARNING
Electrical Shock Hazard
a
Drain Hose - Cut Here
if Needed
b
Screw-Type Clamps
c
Drain Hose
d
Drain Trap
e
Waste Tee
Advertisement
Table of Contents
